When replacing a motorcycle tyre, it is important to make sure that the tire is positioned correctly relative to the rim and that the wheels are adjusted in balance according to the design requirements of the specific type of vehicle. Otherwise, it will lead to abnormal running of the wheel, causing the vehicle to turn in the course of moving, resulting in jitter, resulting in instability of the vehicle at high speed, and directly affecting the safety of driving.
The tyre is mounted, should make the valve hole valve of the tire side Paint Marker and the rim of the balance is 1. if the tire side rotation direction arrow mark, must also make the rotation direction of the tire and the wheel rotation direction by mark.
In order to improve the stability of high speed driving, a mass balance block is arranged on the wheels of some large and medium motorcycle wheels. In this regard, from the car manual, maintenance manual that.
For a matter, the wheel balance block, in the installation of the tire, the tire valve hole side Paint Marker and the rim of the balance, the direction of rotation of the direction of the arrow side of the tire and wheel to, right on the tire and wheel surface, and put the whole hi - Ma must balance adjustment of the wheel are as follows: 3 the method. According to the provisions of the requirements of tire inflation pressure, together with the wheel brake disk are arranged on the 1 special inspection of apricot bracket according to the driving direction of the vehicle at the wheel rotation to 3 wheel to stop rotating, the wheels of the bottom part, marking 14.
Then rotate the wheels to move 9051 mark, loosen the wheel on the wheel, to stop rotating, marking are at the lowest at 6, 45 will be repeated several times, each time to stop rotating wheel. When the positions of the markers are coincident, a weight block is first used, and the smallest balance block 1 is fixed at the top of the wheel, which is 80 of the difference from the mark point and rotates the wheel. Mark 1 movement 90. and balance block in horizontal position 8, at this time loose; after the wheel, mark should keep in the horizontal position, otherwise, should change the balance block, change the quality of the balance block. Until the mark, and the balance block can be maintained in the horizontal, balance, good adjustment of the wheel. Each time it stops turning, the kidneys at its lowest point are different.
It should also be noted that the balance pieces must be supplied with the vehicle. Otherwise. Will affect the stability of the balance block installation, will be in the vehicle wave rejection, shall not take the design of fixed balance block. Will destroy the balance of the wheel.
