The first step: to find the location of the hole, the foreign body will be inserted into the tire, pulled out with pliers.

The second step: with a cone file inserted into the tire was pulled out of the hole, twitch back and forth several times, the purpose is to hole the wound file out the stubble, so as to insert the tape can be closely combined.

Step third: remove the tape, it penetrates into the tip of the holes in the awl, and make eyes at both ends of the rubber cone length, and then put both ends of the strip into one string.

The fourth step: the guide strip with an awl slowly into the hole in the tire, the insertion depth to enter inside the tire rubber strip can be five cm in length, but also ensure the glue exposed tire outside of not less than 1 cm. The important thing to note in this step is to make sure that the bar is inserted into the tyre.

The fifth step: to pull out from tyre awl. Pull out when the action should be slow, in order to ensure the awl pulled out at the same time, the original into the tyre rubber strip with two shares. In the fourth step, the existing two shares of rubber strip is inserted into the tire is rolling out of the hole; and the pulling out awl, the tire is punctured in the hole of the rubber strip should be four shares. The resulting two strands do not have to be taken out of the tyre, but make sure they fit into the hole that has been pierced. The success of the tire, this step is very important. Often encountered in this step, the problem has two kinds: one is pulled out when the awl strips could not be again out of two shares, which are tied strips in the hole or two shares, can not guarantee the hole by glue tight sealing; two is pulled out of the awl too hard and glue this article has been inserted with a tire, tire failure caused.

The sixth step: give the car enough gas, wipe the saliva around the rubber strip to check if there is any leakage. If there is a leak, tire that failed, according to the above steps again; if no leakage is successful.

The seventh step: use the blade to expose the outer part of the rubber strip off, so that the tire external smooth.