1.Always check the tire pressure. The tire pressure must be inflated according to the national standard for the corresponding air pressure specified by different types and sizes of tyres. According to the tyres, the front and rear wheel pressure recommended by the car manufacturer and the tire manufacturer can be inflated.

For the new tyres, the size will change (inflation) after a period of time, and the corresponding internal pressure will decrease. When we find flat tires and low atmospheric pressure, we should add air pressure to reduce the harm of low pressure on tyres. (Note: every time the tire is inflated, use soapy water to check the leak at the valve mouth and screw the valve cover so as not to do any useless work. At the same time, the vehicle's spare wheel should always be available

2.Don't overload. For tyres, at standard pressure, if the load is too high, it is similar to the low pressure, so the possible failure at low pressure may occur at high load. Increase the load, increase the air pressure accordingly, and reduce the running speed at the same time, otherwise it will be very dangerous.

Overload is not only very easy to cause abnormal wear of tires, seriously affect the tire life, but also easy to cause safety accidents, so we should pay special attention to, in strict accordance with the vehicle configuration.

3.Service speed. In high speed faster, the first will make the possibility of increasing tire slippage, calorific value increase, will shorten the service life of the tire; second more heat, if the cooling effect is not good, prone to failure; third due to excessive speed, the brake will often excessive, the tire consumption, is not conducive to the long-term use of tire the. Therefore, we should try to control the speed of the vehicle, do not exceed the maximum tire speed, reduce security risks.

4.Tyres need to be transposed. As the general front wheel is affected by the brake device, it is prone to eccentric wear. The rear wheel is more heavy because of heavy load, especially for the driving wheel. So it's important to change the tire position in good time. The utility model can reduce partial wear and wear to the smallest extent so as to give full play to the utility of each tyre, and finally to prolong the service life of the tyre. Timely transposition of tires can also early detection of vehicles in the tilt angle and so on.

5.Be sure to drive safely, and that's the most important thing. Tire at high speed after pressure cannot deflate; try to avoid sudden start, brake, turn; prevent overloading, speeding; in special weather or environment (such as rain, fog, snow, mud road, etc.) should be careful when driving speed; for poor road, try to avoid the impact of the severe tire encounter corners; slow down; maintain appropriate driving distance; regular tire inspection, maintenance and repair of transposition, etc.; the renovated tire ban installed in the front tire wear to wear; marking must be replaced; tire failure, should be replaced immediately. Doing these things is not only good for the tyres, but more importantly, a guarantee for our physical health. So, everybody, please pay more attention to it.