Automobile sealing tape is one of the important parts of automobile, which is widely used in the parts of door, window, body, seat, skylight, engine box and trunk, etc.Experience in the use and maintenance of automotive gaskets is Shared below.

Methods/steps

1

Always check the seals for large cracks and breakage.

If the rubber strip of the car is not regularly checked to see if there is any crack, especially if there is any break, it should be repaired in time to avoid leakage from heavy rain.We can buy a special adhesive for sealing the rubber strip of the car to stick on, if the larger place is not easy to repair, then professional maintenance staff to deal with it.

2

Clean up the dirt and gravel on the automobile sealing tape in time.

In some places with poor environment, the soil and gravel are more abundant and easy to be blown onto the sealing strip, which will cause certain corrosion effects after a long time. Therefore, it is necessary to timely clean up, and small spades can be used to remove those out of reach.

3

Don't use your hands to scrape the car seal.

When closing the door, be careful not to grasp the sealing strip by hand, especially not to let children scratch the tape with their hands. It will fall off easily after a long time, and you can no longer recover.So pay attention to the details of closing the door. You should hold the door handle or the metal edge of the door, not the sealing strip.

4

When we replace the glass, we should check whether the sealing strip is damaged.

In some unusual accidents, or glass damage, in the replacement of glass, to check the sealing strip for damage, whether the glass cut.If there are cracks, repair as quickly as possible to prevent the scope of the damage from getting bigger.Be careful to change the glass and do not scratch the sealing strip.

5

Take care of the skylight seal.

The sealing strip above the car skylight is special. After opening the skylight, the sealing strip will be exposed to the sun for a long time. Therefore, it will age faster.In areas where there is a lot of wind and sand, the gravel soil inside the seal groove should be cleaned regularly.

6

Usually car washing is done with a high water gun, try not to spray the sealing strip with a high pressure water gun.High water pressure can easily cause the seal bar to deform. Once the deformation is hard to block the water droplets, which will affect the sound insulation and airtight effect of the vehicle for a long time.

7

Reduce vehicle exposure time.

In the summer, when the sun is very hot, do not directly park the car under the sun exposure, so long time easy to cause the sealing strip to become brittle aging, reduce the service life.It is best to park in the shade or in the garage. If you cannot avoid parking in the open air, you can use sunshade, sunshade, sunshade and other equipment to protect the vehicle, protect the sealing strip and extend its service life.